Shellholder Deck Height

[9.3x64]

Hi,
Standard shellholder deck height is 0.125 inches.
I need a deck height of 0.110 inches to size for reliable feeding.
Is 0.015 inches to much to take off a RCBS shellholder?
Will it still extract cases from the die reliably, or will it let me down one day?
Has anyone taken 0.015 inches off a shellholder and used it to load a lot of cases without failing?

Thankyou Allan

[secondtry]

I don't think .015 will weaken it.

Suck it and see. If it does fail, it is unlikely to be total and spontaneous, and even if it is, there will be a way to get another shell holder into the press.

[9.3x64]

I bit the bullet and am having the die shorten 15 thou instead.

[secondtry]

That'll work. And if by any chance in the future you need some of that .015 back, the Redding extra height shell holders are convenient.

[9.3x64]

That'll work. And if by any chance in the future you need some of that .015 back, the Redding extra height shell holders are convenient.

Yes they are.

[deerhunter338mag]

I had to have it done with my 338lapimp as the dies couldn't be adjusted any more for bump. Have never had an issue to date.