K95 22 rimfire

[MM]

I do not consider this an aftermarket barrel but if the moderators do please delete it and accept my apologies
If you want a 22 rimfire for your K95 here is how I did it:

65D42E50-937D-477C-B7C7-150B435AFDC1.jpeg

You must have a 9.3x74R barrel to start with.

B0027777-BF79-477F-AA6D-A9F7C6AB700F.jpeg

Then buy this kit.
From top to bottom plastic rod to install and remove barrel
Barrel
Cartridge holder
22 cartridge
First clean your barrel of carbon deposits and dry it by running some patches through it
Insert the barrel into the your barrel from the chamber gently and use the plastic rod to seat it all the way in.

B88FBD96-771E-47C9-9235-4771886AB219.jpeg

The pointer is showing a sleeve you can screw in and out to adjust for headspace this only needs to be done when you first set it up.

[MM]

The next two pictures show the cartridge carrier with and without a cartridge in it.

7C4E6BDB-8BA8-407E-BF00-7F014C3FF33A.jpeg

393B2E33-C560-4887-B219-F007973558EE.jpeg

You load this just as you would a normal round.

8B6DF8D8-86FC-4082-8000-0709624DF354.jpeg

This is how it is seated inside the barrel, you need to take your time setting the headspace correctly so you don’t crush the 22 barrel or push the headspace adjuster to far forward. It is easy to do and took me less than 15 minutes.
I have a separate scope set up for it so I am always ready to load and shoot squirrels chipmunks and targets.
When done shooting push the barrel back out by using the plastic rod inserted from the muzzle. Then I clean my barrel.

[MM]

62BC7ED2-D336-4A5F-B839-199764E56F52.jpeg

50 yard group using CCI segmented hollow points 710 fps load. I haven’t tried a lot of different loads but these are adequate for what I use this for and it kills squirrels.

[MM]

I really wish that Blaser would make a .22 kit for the K95 it is on my Christmas wish list again this year, but until then I have this setup.
Matt

[9.3x64]

Geez, that’s clever.

[jamesc]

Nice solution, ive been looking at the jagerblock and it wouldn't be hard to modify one to work for a rimfire. Might take some trail and error. Barrel would be the easiest part

[stokesrj]

That is excellent accuracy with that particular load, my R8 or Anschutz will not do that. You owe it to yourself to try the 1050 FPS loading of that bullet as it is much more accurate in my rifles and my Ruger 22/45 suppressed anyway. With the 1050 FPS loading I have killed all kinds of varmints and the segmented hollow point is the cat's meow when it comes to low impact velocity terminal performance, it is superb.

[mchughcb]

Very interesting.

[SPEEDY]

Definitely something damn nice to have, I came close with my 22 hornet barrel and trailboss load.
But this is definitely taking it to the next level.